You are here: Suspension Tuning Tips

Suspension Tuning Tips

Note:  Unless noted otherwise, these tuning tips apply to both forks and rear shocks.

Symptoms: Not using full travel, feels harsh, poor traction while making turns

Causes: Overly stiff spring or compression damping

Solutions: Lower air pressure or softer coil springs; reduce compression damping

 

Symptoms: Bottoms out, soft throughout travel

Causes: Spring rate too low throughout travel or too little compression damping

Solutions: More air pressure or stiffer coils springs; increase compression damping

 

Symptoms: Harsh over large bumps, but good over small ones

Causes: Compression damping too high

Solutions: Reduce compression damping

 

Symptoms: Excessive sag, feels soft initially but does not bottom out

Causes: Initial spring rate or preload too low

Solutions: Increase air pressure or spring preload

 

Symptoms: Harsh over small bumps but uses full travel

Causes: Initial spring rate or preload too high, or too much compression damping

Solutions: Lower air pressure or install softer springs; reduce compression damping; reduce spring preload

 

Symptoms: Takes first bump in a series well but harsh over later bumps, poor traction in washboard corners

Causes: Too much rebound damping

Solutions: Reduce rebound damping, if adjustable

 

Symptoms: Front end springs back too quickly after bumps, poor traction in bumpy corners

Causes: Not enough rebound damping

Solutions: Increase rebound damping, if adjustable

 

Symptoms: Lockout not working

Causes: Not enough suspension fluid in the damper; RLC forks only: blowoff threshold knob is fully counterclockwise

Solutions: Check damper suspension fluid level; RLC forks only: turn blowoff threshold knob fully clockwise then cycle fork a few times


WHEREVER YOU RIDE. WHEREVER YOU RIDE.


Bushing Technology & Inspection | Seals & Foam Rings | Control Direction | Oil Volumes | Structural Inspection | Dropout Thickness Inspection | Torque Values | Unit Conversion | Suspension Tuning Tips | Using the Pump | Important Safety Information | Service Intervals | Contact FOX Service | Warranty Information | FOXHelp Service Web Site


Copyright © 2010
FOX Factory Inc.