|
|
|
|
|
Over time the knurled surfaces of the front wheel hub and quick-release skewer wear out the dropout region of the lower leg (see Dropout photo below).
Inspect and measure the thickness of the dropouts every 6 months or 100 hours. Ensure that any point on the surface is above the minimum specification of 6.20mm (see Measure Dropout photo below).
Replace the lower leg assembly if the dropout thickness is at the minimum specification or smaller.
Dropout
Measure Dropout
Bushing Technology & Inspection | Seals & Foam Rings | Control Direction | Oil Volumes | Structural Inspection | Dropout Thickness Inspection | Torque Values | Unit Conversion | Suspension Tuning Tips | Using the Pump | Important Safety Information | Service Intervals | Contact FOX Service | Warranty Information | FOXHelp Service Web Site
Copyright © 2010
FOX Factory Inc.