SERVICE PROCEDURES

2018-2020 36 FLOAT NA2 Air Spring Tuning with Air Volume Spacers

Required Tools

  • 027-00-018 Pump: Fox Digital HP w/ Bleed, Foldable, Replaceable Battery, 350 psi
  • 398-00-706 Tooling: Fork Topcap Socket, 32mm V2, 3/8 Drive

Supplies Needed

  • Ratchet
  • Torque Wrench

WARNING: Always wear safety glasses and protective gloves during service to prevent potential injury. Failure to wear protective equipment during service may lead to SERIOUS INJURY OR DEATH.

Changing volume spacers in the 36mm FLOAT NA2 fork is an easy internal adjustment that allows you to change the amount of mid stroke and bottom out resistance.

  • If you have set your sag correctly and are using full travel (bottoming out) too easily, then you could install one or more spacers to increase bottom out resistance.

  • If you have set your sag correctly and are not using full travel, then you could remove one or more spacers to decrease bottom out resistance.

 32-34-air-spring-curves.jpg

 

chart-with-space.jpg

*DO NOT EXCEED THE MAXIMUM NUMBER OF VOLUME SPACERS LISTED ABOVE!

 

36mm FLOAT NA2 volume spacer PN: 234-04-736 is orange and has a volume of 10cc.

36-NA2-topcap-with-spacers-.75-view.jpg 

 

The video below guides you through the removal or installation of the 36mm FLOAT NA2 air volume spacers.

 

WARNING: FOX products should be serviced by a trained bicycle service technician, in accordance with FOX specifications. If you have any doubt whether or not you can properly service your FOX product, then DO NOT attempt it. Improperly serviced products can fail, causing the rider to lose control resulting in SERIOUS INJURY OR DEATH.

WARNING: Never attempt to modify air volume spacers, as this can damage your fork causing a loss of control of the bicycle leading to SERIOUS INJURY or DEATH.

WARNING: FOX suspension products contain pressurized nitrogen, air, oil, or all 3. Suspension misuse can cause property damage, SERIOUS INJURY OR DEATH. DO NOT puncture, incinerate or crush any portion of a FOX suspension product. DO NOT attempt to disassemble any portion of a FOX suspension product, unless expressly instructed to do so by the applicable FOX technical documentation, and then ONLY while strictly adhering to all FOX instructions and warnings in that instance.

WARNING: Modification, improper service, or use of aftermarket replacement parts with FOX forks and shocks may cause the product to malfunction, resulting in SERIOUS INJURY OR DEATH. DO NOT modify any part of a fork or shock, including the fork brace (lower leg cross brace), crown, steerer, upper and lower leg tubes, or internal parts, except as instructed herein. Any unauthorized modification may void the warranty, and may cause failure or the fork or shock, resulting in SERIOUS INJURY OR DEATH.