SERVICE PROCEDURES
2020+ Grip/Rail and 2025 GRIP SL Remote Installation
WARNING: Always wear safety glasses and protective gloves during service to prevent potential injury. Failure to wear protective equipment during service may lead to SERIOUS INJURY OR DEATH.
WARNING: FOX products should be installed by a qualified bicycle service technician, in accordance with FOX installation specifications. If you have any doubts as to whether or not you can properly install the remote lever on your bicycle, defer to a professionally trained bicycle service technician. Improperly installed products can fail, causing the rider to lose control, potentially causing SERIOUS INJURY OR DEATH.
WARNING: Make sure that the remote lever does not interfere with normal brake and shift lever operation. Failure to do so can result in loss of control, potentially causing SERIOUS INJURY OR DEATH.
WARNING: Make sure to leave enough cable housing length to accomodate normal steering operation. Failure to do so can result in loss of control, potentially causing SERIOUS INJURY OR DEATH.
2020+ GRIP/Rail and 2025 GRIP SL Remote (Push-to-Lock)
NOTE: When turning the pulley to it's stopping point, do not overtighten after gently hitting the hard stop. Overtightening may cause internal damage that could require replacement of the topcap assembly.
Step 1
If you have just purchased a new Grip Remote (Push-to-Lock) fork, start here to view instructions on how to attached your remote lever. If your Topcap Interface Parts (the remote pulley, cable housing stop, and torsion spring) have been removed or if you are having issues with the pulley returning, please first go to the Topcap Interface Part Installation video appropriate to your configuration to make sure that your fork is setup correctly.
2020 GRIP Remote Topcap Interface Part Installation »
2020+ GRIP/Rail and 2025 GRIP SL Remote (Push-to-Unlock)
NOTE: When turning the pulley to it's stopping point, do not overtighten after gently hitting the hard stop. Overtightening may cause internal damage that could require replacement of the topcap assembly.
Step 1
If you have just purchased a new Grip Remote (Push-to-Unlock) fork, start here to view instructions on how to attached your remote lever. If your Topcap Interface Parts (the remote pulley, cable housing stop, and torsion spring) have been removed or if you are having issues with the pulley returning, please first go to the Topcap Interface Part Installation video appropriate to your configuration to make sure that your fork is setup correctly.