SERVICE PROCEDURES

2020+ Grip/Rail Remote Topcap Interface Part Installation

WARNING: Always wear safety glasses and protective gloves during service to prevent potential injury. Failure to wear protective equipment during service may lead to SERIOUS INJURY OR DEATH.

WARNING: FOX products should be serviced by a qualified bicycle service technician, in accordance with FOX specifications. If you have any doubt whether or not you can properly service your FOX product, then DO NOT attempt it. Improperly serviced products can fail, causing the rider to lose control resulting in SERIOUS INJURY OR DEATH.

WARNING: FOX suspension products contain pressurized nitrogen, air, oil, or all 3. Suspension misuse can cause property damage, SERIOUS INJURY OR DEATH. DO NOT puncture, incinerate or crush any portion of a FOX suspension product. DO NOT attempt to disassemble any portion of a FOX suspension product, unless expressly instructed to do so by the applicable FOX technical documentation, and then ONLY while strictly adhering to all FOX insturctions and warnings in that instance.

WARNING: Modification, improper service, or use of aftermarket replacement parts with FOX forks and shocks may cause the product to malfunction, resulting in SERIOUS INJURY OR DEATH. DO NOT modify any part of a fork or shock, including the fork brace (lower leg cross brace), crown, steerer, upper and lower leg tubes, or internal parts, except as instructed herein. Any unauthorized modification may void the warranty, and may cause failure or the fork or shock, resulting in SERIOUS INJURY OR DEATH.

2020 GRIP/Rail Remote (Push-to-Lock)

NOTE: Do not overtighten the black compression needle during remote topcap interface part installation. Overtightening of the needle can cause internal damage that may require replacement of the topcap assembly.

Step 1

This video guides you through the correct installation and setup of the 2020 GRIP Remote Topcap Interface Parts in the Push-to-Lock configuration to prepare for remote cable installation. 

Once Topcap Interface Part Installation is complete you can finalize your setup by installing the remote lever. Videos guiding you through proper remote installation can be found here: 2020 GRIP Remote Installation »

2020 GRIP/Rail Remote (Push-to-Unlock)

NOTE: Do not overtighten the black compression needle during remote topcap interface part installation. Overtightening of the needle can cause internal damage that may require replacement of the topcap assembly.

Step 1

This video guides you through the correct installation and setup of the 2020 GRIP Remote Topcap Interface Parts in the Push-to-Unlock configuration to prepare for remote cable installation. 

Once Topcap Interface Part Installation is complete you can finalize your setup by installing the remote lever. Videos guiding you through proper remote installation can be found here: 2020 GRIP Remote Installation »