|
|
|
|
|
Over time, the textured contact point surfaces of the front wheel hub and quick release skewer wear out the contact surfaces of the fork dropouts. Inspect and measure the thickness of the dropouts every 6 months or 100 hours. Ensure that any point on the surface is above the minimum specification of 1/4 inch, or 6.20 mm.
 Dropout |
 Measure Dropout |
Replace the lower leg assembly if the dropout thickness measures at the minimum specification, or less.
|
|
|
Bushing Technology & Inspection | Control Direction | Oil Volumes | Structural Inspection | Dropout Thickness Inspection | Torque Values | Unit Conversion | Suspension Tuning Tips | Using the Pump | Important Safety Information | Service Intervals | Contact FOX Service | Warranty Information | FOXHelp Service Web Site
Copyright © 2012
FOX Factory Inc.