GRIP SL Remote Push-to-Lock

Step 1

Torque the compression needle to 2.5 in-lb by turning it clockwise using the compression needle driver (PN: 398-01-362). This will place it in the lockout position.

Step 2

Sub-assemble the Top Cap interface parts. Place the Torsion Spring, aligning the vertical leg of Torsion Spring, into the hole in the bottom of the Cable Remote Pulley. Align the Pulley Set screw facing the dot opposite to the arrow. Engage the horizontal tang of the torsion spring with the Cable Housing as shown.

Step 3

Install sub-assy onto Damper facing desired direction for cable routing. 

Step 4

Rotate the pulley (clockwise) to lock out postion. When rotating the pulley  make sure to clear the damper wrench flats so while rotating the pulley you are turning the comp needle. While holding the pulley and housing in place with downward pressure,  install and tighten the Pulley set screw to 4in/lbs. The pulley should return freely after lockout.

GRIP SL Remote Push-to-Unlock

Step 1

Torque the compression needle to 2.5 in-lb by turning it clockwise using the compression needle driver (PN: 398-01-362). This will place it in the lockout position.

Step 2

Sub-assemble the Top Cap interface parts. Place the Torsion Spring, aligning the vertical leg of Torsion Spring, into the hole in the bottom of the Cable Remote Pulley. Align the Pulley Set screw facing the dot opposite to the arrow. Engage the horizontal tang of the torsion spring with the Cable Housing.

Step 3

Install sub-assy onto Damper facing desired direction for cable routing. 

Step 4

Rotate only Cable Pulley 270° CW (Clockwise) to preload Torsion Spring. Check cable direction. When locked out, check that Pulley Set Screw is alingned to Mark. Torque screw to 4in/lbs while holding Pulley. Pulley must return freely after unlock.